Take it out low and slow, might be a false positive.Just says an error occurred during cal. Try again. Yes it was cool.
Did you install the correct firmware for your bird and confirmed it completed successfully on both the bird and tx? Try reinstalling the app? or a rebind/stick calibration?It's going to be low and slow because the motors won't even start.All this since firmware update.
Did rebind, stick cal.1.2.8 installed , did controller. nothing. When the P3 starts up the camera goes through it's motions ,is horizontal for 5 seconds then points straight down. It is sending a live feed though.Did you install the correct firmware for your bird and confirmed it completed successfully on both the bird and tx? Try reinstalling the app? or a rebind/stick calibration?
cooled off in fridg , no luck.Take battery out and wait an hour so it can cool down properly.
Then do the imu calibration the moment you power up the phantom. Its best to have your device on the imu screen so its faster to do the calibration
Yep, DJI told me to send it in.Gal on tech support. I don't think she had a clue. Put me on hold to talk to somebody else.. They think it's the main board . MC error. Thanks all for the help. KADIs it a P3A
Can you upload the update logs from the 1.28 process?Yep, DJI told me to send it in.Gal on tech support. I don't think she had a clue. Put me on hold to talk to somebody else.. They think it's the main board . MC error. Thanks all for the help. KAD
I did. I installed the latest and greatest this morning.She's boxed up right now.Can you upload the update logs from the 1.28 process?
We use essential cookies to make this site work, and optional cookies to enhance your experience.