Height limited to 100 feet, no gimbal.

[gunga galunga]

I have a 3 pro without a gimbal that has no flight restrictions. I bought a crashed 3 pro that had the camera torn off. Removed the gimbal and got it flying. However, the green lights turn red at 100 feet and it will not elevate. I don't think a different firmware would have a 100 foot limit. What is causing this ? Is there software other than Dji go or Litchi to set limits ? If I put a gimbal and camera on it would a Dji Go height limit change fix this ? Thanks.

 

[gunga galunga]

I have a 3 pro without a gimbal that has no flight restrictions. I bought a crashed 3 pro that had the camera torn off. Removed the gimbal and got it flying. However, the green lights turn red at 100 feet and it will not elevate. I don't think a different firmware would have a 100 foot limit. What is causing this ? Is there software other than Dji go or Litchi to set limits ? If I put a gimbal and camera on it would a Dji Go height limit change fix this ? Thanks.

Lack of satellites ? Never ever had this happen. Will replace gps unit.

 

[Oso]

I have a 3 pro without a gimbal that has no flight restrictions. I bought a crashed 3 pro that had the camera torn off. Removed the gimbal and got it flying. However, the green lights turn red at 100 feet and it will not elevate. I don't think a different firmware would have a 100 foot limit. What is causing this ? Is there software other than Dji go or Litchi to set limits ? If I put a gimbal and camera on it would a Dji Go height limit change fix this ? Thanks.

I can only think of a couple of common things. Maybe it's set to beginner mode. Max height is enabled and set to a low limit. FW flight restrictions that came out with 11.20 are active and need the steps to disable such as signing in, etc. It's been a minute, so all of this is sort of foggy within my oldness.

 

[gunga galunga]

I can only think of a couple of common things. Maybe it's set to beginner mode. Max height is enabled and set to a low limit. FW flight restrictions that came out with 11.20 are active and need the steps to disable such as signing in, etc. It's been a minute, so all of this is sort of foggy within my oldness.

Yea, me too. I'm put a dji gimbal on it.
Will try the registration route via Dji Go.