So I crashed my phantom pro 3, replaced the body and it worked fine. Once. Next time I took it out the gimball/camera goes crazy.
Sign in - Google Accounts
Hopefully that link works.
The camera rests at an angle.it it just rotates back and.forth. remote error switches between nothing and ginball motor over load. Calibrating gimball fails.
I just replaced the ribbon cable from.logic board to gimball as it was a bit bentup. Didn't help. Any other ideas?
Sign in - Google Accounts
Hopefully that link works.
The camera rests at an angle.it it just rotates back and.forth. remote error switches between nothing and ginball motor over load. Calibrating gimball fails.
I just replaced the ribbon cable from.logic board to gimball as it was a bit bentup. Didn't help. Any other ideas?
Last edited: