The Spark has some new procedures that are not currently found in other DJI drones, so there is a slight learning curve (even more so if you've never owned a DJI drone). I found everything to be pretty easy to do after learning those new procedures. Without a good source of instruction, some people are no doubt going to struggle with these things.Each step was a challenge from finding my aircraft linking controller, and downloading the firmware.
The Spark has some new procedures that are not currently found in other DJI drones, so there is a slight learning curve (even more so if you've never owned a DJI drone). I found everything to be pretty easy to do after learning those new procedures. Without a good source of instruction, some people are no doubt going to struggle with these things.
Yes.do you own the spark?
Do you have a remote controller? If so, holding the power button for 2 beeps will disconnect it from the Spark (allowing you to connect with your mobile device). Holding the power button for 3 beeps will reset the Spark's Wi-Fi.It never shows up automatically on my phones wifi. I have to manually hold the power button down on the battery for the 2 beeps before i see it.
Yes.
Do you have a remote controller? If so, holding the power button for 2 beeps will disconnect it from the Spark (allowing you to connect with your mobile device). Holding the power button for 3 beeps will reset the Spark's Wi-Fi.
You can fly with just the remote controller (no mobile device connected). It's not a great idea since you cannot see what's going on in DJI GO, but it's possible.Cause you cant fly the drone on just the remote only correct?
That double beep process disconnects the remote controller from the Spark. You'll always need to do that once after flying with the remote controller. After doing it, you should be able to fly with your mobile device over and over again (until you reconnect the remote controller).When just using my phone only and drone? And this is what i was talking about was troubling me. The spark wifi would not be recognized by my phone, so i have to press and hold the button for the 2 beeps.
You can fly with just the remote controller (no mobile device connected). It's not a great idea since you cannot see what's going on in DJI GO, but it's possible.
That double beep process disconnects the remote controller from the Spark. You'll always need to do that once after flying with the remote controller. After doing it, you should be able to fly with your mobile device over and over again (until you reconnect the remote controller).
That's correct. When the light on the remote controller turns green, you're connected and ready to fly.if i just turned on the remote and drone (no mobile device), it should connect (in remote mode) and i would be flying blind so to speak?
That's correct. When the light on the remote controller turns green, you're connected and ready to fly.