- Joined
- Aug 5, 2014
- Messages
- 2
- Reaction score
- 0
Decisions, Decisions
DJI Phantom Vision 2 + / Stock Cam
A recent crash pulled the wires out of the connector (3, see illustration) for the Vision board. I believe the connector can be replaced without replacing the whole cable ribbon. My biggest dilemma is that I haven't been able to analyze a schematic (if even available) or create my own to properly place the connector back on in the correct position.
Given that... is there anyone that could snapshot or illustrate the proper position the connector should be placed on for the section that contains (4) wires going to the Vision board. I am hoping to either find a replacement at a local radio shack or electronic shop. Last resort, change the whole ribbon.
DJI Phantom Vision 2 + / Stock Cam
A recent crash pulled the wires out of the connector (3, see illustration) for the Vision board. I believe the connector can be replaced without replacing the whole cable ribbon. My biggest dilemma is that I haven't been able to analyze a schematic (if even available) or create my own to properly place the connector back on in the correct position.
Given that... is there anyone that could snapshot or illustrate the proper position the connector should be placed on for the section that contains (4) wires going to the Vision board. I am hoping to either find a replacement at a local radio shack or electronic shop. Last resort, change the whole ribbon.