Well it finally happened haha, was landing the phantom in a hurry as it was coming back from a decent flight with a headwind. Landed it and it started hopping along the ground, and the CSC wouldn't shut it down for some reason.
Rotor guards did their job and it ended up flipping over, unfortunately the drop pins let go and the gimbal flew off and ripped the connector clear off the receiver board. Gimal is still fine and self tests ok but the board is toast, tried to patch repair but the was just too difficult with all the traces gone except one.
Anyway just wanted to see if anyone else has had their connector tear off like that or was it just really bad luck? Trying to work out a solution so it doesn't happen again as its a $400 board and it seems like DJI designed it to fail at the most expensive spot. Considering cutting the cable in the middle and putting an inline connector in that would hopefully separate instead.