Yesterday I took my V+ for a small flight with the children in our garden which is reasonably spacious, where it is enough for small children to play a soccer game. The bird powered up normally, calibrated equally good as always, I let it hover for a little while checked all the controls they are all working and the bird was responding accordingly. Although I noticed that it was trying to stay locked on position while hovering but I attributed that to slight wind factor that was around. The problem started when I tried to rotate the bird on its axis then that is when the bird started to drift sharply to the left and no matter what I do it was very difficult to control its direction, needless to say that I crashed to time but the bird in totality was fine, then I recalibrated it again and hovered on a height less than 6 feet, the same happened when I tried to rotate the bird sharp banks to the left where I eventually cut the power and made it drop to the ground. Needless to say that at times it was struggling to maintain a 3 foot hover immediately after launch.
Returned home last night, connected the bird to the computer and recalibrated everything and checked it had all the new firmware, needless to say it did not any calibration, except the IMU. I calibrated that as Basic and Advance, did not fly it since. Anyone has an idea as to what has happened? I am concerned that if I go out and fly it, I might have a flyaway?
Thanks in advance for reading and feedback.
Regards,
Sarie
Returned home last night, connected the bird to the computer and recalibrated everything and checked it had all the new firmware, needless to say it did not any calibration, except the IMU. I calibrated that as Basic and Advance, did not fly it since. Anyone has an idea as to what has happened? I am concerned that if I go out and fly it, I might have a flyaway?
Thanks in advance for reading and feedback.
Regards,
Sarie