How should I be wiring the following?:
GoPro Hero 3+
Zenmuse H3-3D
Lightbridge
Naza M v2
The Naza v2 PMU only has one extra CAN Bus port, currently I have the Lightbridge plugged into it. Tested and works fine. However, when adding the H3-3D gimbal it also needs to connect to CAN bus, but I have no where to plug it in.
With this setup, do I need a CAN hub in order to run both Lightbridge and H3-3D?
Any help appreciated. Thanks!
GoPro Hero 3+
Zenmuse H3-3D
Lightbridge
Naza M v2
The Naza v2 PMU only has one extra CAN Bus port, currently I have the Lightbridge plugged into it. Tested and works fine. However, when adding the H3-3D gimbal it also needs to connect to CAN bus, but I have no where to plug it in.
With this setup, do I need a CAN hub in order to run both Lightbridge and H3-3D?
Any help appreciated. Thanks!