Hi guys...Hope someone can help!
Got my Phantom a few days ago. Everything was working fine and I decided to enable IOC.
Downloaded Naza Assistant software, connected Phantom.....it told me to upgrade firmware
Clicked the upgrade button...everything seemed to be going fine......then transmitter and phantom began to beep.
Turned everything off and tried to start the Phantom up outside, and all I can get is a constant blinking yellow LED
Thought that the transmitter needed to be paired with the receiver so referred to the advanced manual which told me to remove the housing and locate the receiver module which should have a LED and link button.
Although I can locate the module (I think) it doesnt have a LED or button
Ive calibrated the transmitter which hasnt made any difference.
When I open the Naza software, nothing happens when I move the transmitter paddles.
I also downloaded and imported parameters, and restored default settings
Can anyone help before I go completely bonkers
Got my Phantom a few days ago. Everything was working fine and I decided to enable IOC.
Downloaded Naza Assistant software, connected Phantom.....it told me to upgrade firmware
Clicked the upgrade button...everything seemed to be going fine......then transmitter and phantom began to beep.
Turned everything off and tried to start the Phantom up outside, and all I can get is a constant blinking yellow LED
Thought that the transmitter needed to be paired with the receiver so referred to the advanced manual which told me to remove the housing and locate the receiver module which should have a LED and link button.
Although I can locate the module (I think) it doesnt have a LED or button
Ive calibrated the transmitter which hasnt made any difference.
When I open the Naza software, nothing happens when I move the transmitter paddles.
I also downloaded and imported parameters, and restored default settings
Can anyone help before I go completely bonkers