- Joined
- Dec 31, 2014
- Messages
- 60
- Reaction score
- 1
Hi All
Been using a Chinese gimbal on my Phantom for a couple of days. Broadly speaking it's worked fine, but now I've found it doesn't move at all. Disconnected pitch control so it's only connected to + and - power and it doesn't move at all. The board is recognised when connected via USB but the motors arent' moving at all. it's the sort with a micro switch for manual tilt setting etc - I'm thinking it's dead and needs returning but before I do this wondered if anyone had any tips on what else to check or if there's any sort of manual reset I could try?
Been using a Chinese gimbal on my Phantom for a couple of days. Broadly speaking it's worked fine, but now I've found it doesn't move at all. Disconnected pitch control so it's only connected to + and - power and it doesn't move at all. The board is recognised when connected via USB but the motors arent' moving at all. it's the sort with a micro switch for manual tilt setting etc - I'm thinking it's dead and needs returning but before I do this wondered if anyone had any tips on what else to check or if there's any sort of manual reset I could try?