- Joined
- Oct 24, 2014
- Messages
- 4
- Reaction score
- 0
Hello to everybody,
I need help to remapping correctly the channels on t8j mode 2 (futaba) remote control, because my P2 doesn't works properly...
At the moment the channels assignments are:
A --> 1
E --> 2
T --> 3
R --> 4
5 --> 5 (switch sw E)
6 --> 6 VR (dimmer on tx)
U --> 7 (3 positions switch sw C)
8 --> 8 (switch sw F)
The main problem is that the P2 goes into failsafe when sw C is in position 1 and 3. It runs correctly only when the switch sw C is in the middle.
The second problem is that the P2 doesn't have the tilt control on gimbal by dimmer VR.
For about the failsave I tried to set the endpoints of "U" to 70% but it doesn't works anyway.
Are there somebody that can help me?
Really many thanks in advance.
Michele
I need help to remapping correctly the channels on t8j mode 2 (futaba) remote control, because my P2 doesn't works properly...
At the moment the channels assignments are:
A --> 1
E --> 2
T --> 3
R --> 4
5 --> 5 (switch sw E)
6 --> 6 VR (dimmer on tx)
U --> 7 (3 positions switch sw C)
8 --> 8 (switch sw F)
The main problem is that the P2 goes into failsafe when sw C is in position 1 and 3. It runs correctly only when the switch sw C is in the middle.
The second problem is that the P2 doesn't have the tilt control on gimbal by dimmer VR.
For about the failsave I tried to set the endpoints of "U" to 70% but it doesn't works anyway.
Are there somebody that can help me?
Really many thanks in advance.
Michele