- Joined
- Jun 5, 2014
- Messages
- 18
- Reaction score
- 0
No point in me replacing the control board if you tried it and it made no difference.
Thanks breweraz, we'll figure it out somehow.
Thanks breweraz, we'll figure it out somehow.
superbee383 said:No point in me replacing the control board if you tried it and it made no difference.
Thanks breweraz, we'll figure it out somehow.
skyviewpix said:superbee383 said:No point in me replacing the control board if you tried it and it made no difference.
Thanks breweraz, we'll figure it out somehow.
Have you had any luck with it? I sent my phantom back to DJI via the dealer where purchased, hoping for a quick solution, however I have heard that it could take a long long time before I see the phantom again, of course, I will post what the problem is, as soon as I hear.
P.S did you also have a problem with the tilt? mines wasn't tilting either
Drone6 said:skyviewpix said:superbee383 said:No point in me replacing the control board if you tried it and it made no difference.
Thanks breweraz, we'll figure it out somehow.
Have you had any luck with it? I sent my phantom back to DJI via the dealer where purchased, hoping for a quick solution, however I have heard that it could take a long long time before I see the phantom again, of course, I will post what the problem is, as soon as I hear.
P.S did you also have a problem with the tilt? mines wasn't tilting either
Tilt function is not working through the app. however, I could change the angle using the assistant software while connected to the Phantom.
superbee383 said:skyviewpix,
I can tilt the camera but not showing on the App.
I can't wait to find out what is causing this problem.
Thanks
Drone6 said:Just returned from short range flight. All telemetry is now gone. The only function is the video feed, wifi signal strength and micro sd card capacity. All elevation distance etc. not working now. I will have to rely on line of sight and a watch. Paper airplanes are beginning to look fun now.
andyparker said:App 1.0.40
Cam 1.1.8
Naza 1.08
Very odd issue... booted up in the basement to get info and all functions worked. Next time I turn it on it might not. It wouldn't have anything to do with boot order... cam, wifi, controller, app?
Anyone else experience this?
andyparker said:Heard bad things about the cam upgrade. Has that been worked out?
ted35,ted35 said:Well...I finally figured out why I'm only getting partial telemetry. After disassembling the camera...monkeying around with the connections...dropping, searching for, and finally finding a microscopic screw, I realized the problem is in the white data cable (figures). Specifically, at the elbow of the male portion of the plug. There seems to be a loose connection that can be "reconnected" if I pull the elbow apart a bit. My short-term (and probably very temporary)fix is to wedge a small rolled piece of duct tape and place it between the camera body and the data cable as it makes the 90 degree bend. Maybe something like this: http://hobbyking.com/hobbyking/store/__ ... 00mm_.html would be a suitable substitute.
-edit-
I ended up picking this up: http://www.ebay.com/itm/3-6Ft-1M-1-8M-3 ... 1c409ea08b It shouldn't be too big of a deal to remove and replace the data cable (famous last words).