After recent crash that bent the shell and broke an ESC & Motor on the left foreword arm. I replaced the shell, motor and ESC. Now on startup I get 4 beeps and 3 red flashes from the new ESC (These beeps are louder and in addition to the normal startup) replaced and there were no lights on the front right. The LEDs on the rear are normal yellow & green. until both sides flash green.With CSC on the controller the engines start and appear to be on sync. I can rev the engines and all LEDs appear normal red flashing on both in front and green flashing on the rear two, and the engines shuts down properly. When I try to take off it flips over. I had already removed the camera and gimbal and was planning on flying LOS until I regained confidence in the bird
I tried replacing the ESC with another new one and I get the same results, I've checked for cold solder connections
Any advice would be appreciated
I tried replacing the ESC with another new one and I get the same results, I've checked for cold solder connections
Any advice would be appreciated