I'm starting to suspect that either the wire ribbon that connects the gimbal to the quad or to the VPS unit of my Phantom 3 Pro is faulty. It started while flying and I kept getting the status bar saying "signal lost"... and while I never lost control of the P3 I had no video. Now it pretty much does it each time I take off. After doing a whole bunch of testing, checking, reloading GO on my tab, trying another phone, and reinstalling the aircraft firmware I started to notice something. If I start it up the video is good, while on the ground I can move my hand in front of the camera and no problems with the moving video but if I pick the P3 up and turn it the video gets blocky and freezes and says "signal lost". I have disconnected the ribbons and reconnected them and it still isn't right. My last test I had the P3 on the ground with the video working perfectly but if I gently move the base of the gimbal just under the vibration dampeners it loses signal again. I cant quite figure out what is loose and what is causing it, has anyone had a similar thing that might help me solve this problem?
Thanks Jase
Thanks Jase