Installed the cyclops today and it went well but when I loaded the settings from the prior installers, I get a few problems. I matched the settings exact but, when I tilt the PV2 to the left as facing it, the RH top of the camera hits the CF mounting plate and the camera drops 90degs. to the left and stays there till I move it by hand to center then it will stay there. Also, full down tilt, it shakes at a high rate till I move it back by hand. Any suggestions?
Barry
After typing above, I noticed that the main mounting arm was all the way up. Loosened the screws and slid it down all the way. It works better but still hits. If I tilt the camera down a bit so the top of the camera misses the CF plate, it works as it should but the least bit of contact and it goes limp. It still jitters when pointed all the way down.
Barry
After typing above, I noticed that the main mounting arm was all the way up. Loosened the screws and slid it down all the way. It works better but still hits. If I tilt the camera down a bit so the top of the camera misses the CF plate, it works as it should but the least bit of contact and it goes limp. It still jitters when pointed all the way down.