- Joined
- Jul 1, 2016
- Messages
- 9
- Reaction score
- 1
- Age
- 32
Hi guys,
So i´m having these two errors (picture)
Any idea on what causes the problem?
I have tried a full factory reset and latest software re-install.
Worth to be mentioned is that the drone has been having a rough summer..
First off i hit a flagpole (the only one within kilometers), this impact smashed one of the rotor arms and the shell had to be replaced.
After some testing, i discovered the next issue, which was that the power port module had a fried chip.
This of course was after an emergency landing in a pond.
Drone was pulled out immediately and put in the oven for about 30 minutes.
I had all kinds of error messages after the pond accident, but the baking fixed all that.
The P4 has been in the air several times after the pond accident, but one day i got this new error and it has not been flying since.
The power port module has been replaced, and this fixed the loss of battery voltage monitoring.
Next up is probably replacing the right ESC center board?
All PCBs has been visually controlled and cleaned with isopropanole.
I´m assuming this is absolutely not a warranty case.
Thanks in advance.
So i´m having these two errors (picture)
Any idea on what causes the problem?
I have tried a full factory reset and latest software re-install.
Worth to be mentioned is that the drone has been having a rough summer..
First off i hit a flagpole (the only one within kilometers), this impact smashed one of the rotor arms and the shell had to be replaced.
After some testing, i discovered the next issue, which was that the power port module had a fried chip.
This of course was after an emergency landing in a pond.
Drone was pulled out immediately and put in the oven for about 30 minutes.
I had all kinds of error messages after the pond accident, but the baking fixed all that.
The P4 has been in the air several times after the pond accident, but one day i got this new error and it has not been flying since.
The power port module has been replaced, and this fixed the loss of battery voltage monitoring.
Next up is probably replacing the right ESC center board?
All PCBs has been visually controlled and cleaned with isopropanole.
I´m assuming this is absolutely not a warranty case.
Thanks in advance.