beeping

  1. MisterSoftee

    Battery Fault after Crash - Any Help?

    So I took off my prop guards because I was going for a flight over the water. It was kinda' windy, and when I came in, I crashed into a sapling. When I got to the drone (about 8 feet away) it was upside-down. I picking it up (still running) and tried to power it down. It wouldn't. I didn't want...
  2. R

    P4ProPlus controller that beeps softly while OFF?

    Hello, I bought a Phantom 4 Pro Plus and unpacked everything, charged my controller and it beeps softly, and continuously, when it is powered down. Anyone ever had something like this?
  3. N

    Professional Firmware Update has really messed up my Drone... Help :/

    Firstly it important to understand I am not a noob and have done an awful lot to try to rectify the issues I am getting at the moment since I upgraded last week... 1) The first big change was a black camera view when going on the DJI Go App before 4. Basically what is happening is I boot up...
  4. D

    Left my Phantom 4 Pro + remote on

    I left my Phantom 4 Pro + Remote on accidentally for over 5 hours. Now after being on for a short while, it beeps continuously and I can't turn it off. (Eventually) I can. Also, now I"m getting all kinds of "Strong Signal interference" warnings. Is there a way to just reset the remote...
  5. A

    P2 vision 2 - Beeping - will not start

    I have a P2 vision. I have flew the heli several times with no problems. I recently wanted to add a camera for remote FPV. I connected the camera power to my NAVA unit and it was working just fine. When I put everything together again it started this beeping sound and no other lights . No...
  6. S

    Dji 4 beeping error at start up

    I went on a hike yesterday and tok my phantom 4 out with me. took it out of my case and did my checklist as always and flew for about 10 minutes. Nothing special, no hard flying , no hard landing. Packed it back up( left battery connected). About 15 min later I take it back out to film another...
  7. Dramface460

    New P4, now having issues with VPS and strange sound

    Hi all, This week I received a replacement drone from DJI. Didnt have much time to fly it until later this week. yesterday I had severe drops in altitude. Called DJI and was told to use the DJI assistant 2 to calibrate the VPS. strange because I did not have to with my original p4 and it was...
  8. jrod1944

    Faint constant beeping.

    I had a big crash and have put my phantom back together. I replaced one bad esc, a bad compass and cable. I am still getting a faint constant beeping. Some one said it could be the Naza, are there other possibilities? Thanks in advance
  9. jrod1944

    Three constantly blinking red lights and constant beeping

    I recently had the biggest crash in 3 years of flying my Phantom 2 Vision Plus. The landing gear was ripped off. In addition to various cracks and scrapes, The compass cable had a break, and the camera took a big hit. I took the camera and gimbal apart and it seems to be working. I ordered a...
  10. J

    P4 Remote Beeping Uncontrollably

    Hi Everyone. I just bought the p4 less than a week ago. After my last flight i left the drone and controller packed ready for my trip (tomorrow....yikes!) When i came in today, the remote was beeping uncontrollably and was quite warm. I turned it off and back on again. When it turned back on, it...
  11. N

    Professional Constant Beeping for over 2 Hours

    Hi, I was wondering if someone could help me diagnose/fix my drone without sending it in. It flew into a wall and flipped and was upside down on the floor with blades spinning when i picked it up. Now it just beeps endlessly. Tried to reset it and update it to no avail; the same beep was...
  12. ALOHARO

    Firmware update started and p2v+ started acting crazy

    Hi all, I had the p2v+ connected to computer for updates etc. I had been a while since I had checked. i also had the RC turned on. A message said I needed a RC update. When I click "upgrade" my p2v+ started beeping and the gimbal started twitching. After a little while of this and thinking...
  13. O

    Newbie Needs Firmware Help

    Purchased P3 Standard yesterday. Installed dji go on android smartphone (LG G4), update notice came up. Downloaded to device the update, followed instructions to connect to p3s via it's wifi. Updated started, got to 14% then error. Said to shut down all, reconnect and restart update process...
  14. M

    Professional flashing red lights and no camera connection, troubleshooting?

    Hi there, I wonder if anyone can shed some light on a problem I've unexpectedly encountered. I used the P3P successfully less than a month ago. At the time all firmware was up to date. I put it back in it's case and that was that. I'm off on a shoot on monday so yesterday I got the thing out...
  15. R

    GPS/Compass issue lead to crash, now some weird behaviour...

    Hey everyone. TL;DR: My Phantom 3 Adv had a compass error and crashed. I replaced the compass but I still get continuous beeping. If i press the board or shake the Phantom a little, the beeping stops. Sometimes it stops infinitely until I shake it again. Sometimes it switches from a beep with...
  16. N

    Standard Phantom 3 standard firmware

    Hi, I've just got a phantom 3 standard and it seemed fine turning on and everything. Went out to test it and it needed a firmware update. So I started to download it with the DJI pilot app and it got to about 50% and stopped. So I shut everything down. Tried again, same problem. So I gave up on...
  17. I

    transmitter: Power flashed red, green flashing and beeps

    I just bought P3 standard. I did power tests and everything was fine. I did firmware update using wifi than tried to fly it and the controller doesnt stop beeping and flashing red. I thought the power may be low so i plug it in the wall and a minute later its solid green. I turn the controller...
  18. A

    Professional Compass error and beeping sound

    Hello Guys, I replaced my Phantom 3 Professional body shell due to cracks with a new one. Used Bondic (great product) to reinforce the shell and put it together again. It took a few hours but it went fine. Only after starting up the Phantom I get the well-known compass error message “Compass...
  19. P

    Does your Phantom 3 beep like an alarm clock after upgrade? [Fix in here]

    Here is the problem I had- I put the new 1.4.0010 BIN file on a freshly formatted SD card and fired the P3P up. It beeped and flashed like it normally does for firmware upgrades. I waited until the gimbal light was green, about a half hour later. I then turned off the bird, and turned it back on...