Zenmuse H3-3D horizon not level. Please help me.

[Garrett Poorbaugh]

Hello, so I bought a DJI Phantom 2 (v2 if that matters) a couple months ago. I crashed it very, very softly. The horizon of the gimbal is off by a few degrees to the left. Here are the things I have done so far to fix it:
Advanced IMU calibration
unbent arms
rebent back arm

It is less slanted, but still noticeable. What else can I do? Thanks.(Here are some pictures. It could be that its level and I'm just crazy, but if you zoom in one side its a little, little bit higher than the other. It also has varying intensity, it might be fine at one time but bad another.)

 

[Qoncussion]

Check out this thread: What's the best Zenmuse alternative gimbal for under $300? | DJI Phantom Forum

 

[Mrsweep]

I had similar , but might not be the case for yours. Make sure it's flat/level on the ground when you power it up. I realised when I turned mine on in my hand the gimbal was slightly off centre, which is what MIGHT be the issue with yours