Versions after last update P4P 8-8-17

[Bakersfield Quad]

OK, I said earlier that I had updated to DJI Go 4 4.1.5 on 8-8-17. I also mentioned that it appeared to update the firmware on the AC and RC, as soon as they were linked to Go 4.

I didn't make note of the versions on everything after the update, so I thought I would post it here,

P4P (new)

RC 1.04.04.00

AC 1.00.01.04

DJI Go 4
4.1.5
1.04.0602

All has worked well since, no issues or odd warnings. I cant say that I see anything wrong with the update. Still haven't looked at everything yet, not sure what was added with the new version. I did not see any "high wind warnings" even though it was blowing 10-15 mph at the time. Before I was getting warnings in the same conditions.

I did have to recalibrate everything after the update, it required it. So, a couple of minutes going through all that and it was fine.

Just wanting to give as much information as I can concerning this new update.

 

[MassGuy]

I'm still on 4.1.3. I read some updates have issues but I haven't had time to dig into it deeper. This version works for me so I'll stick with it for a little while.

 

[azgeek]

Just wanting to give as much information as I can concerning this new update.

Thanks for the report. Let us know when you've had a chance to run it through its paces. I'm curious if you get any spurious NFZ warnings.

 

[Bakersfield Quad]

Thanks for the report. Let us know when you've had a chance to run it through its paces. I'm curious if you get any spurious NFZ warnings.

Will do, so far none have popped up.