I am trying to control a servo (for camera trigger) using the left (IOC) switch on the stock phantom 2 remote. I would like the servo to be activated whenever the switch is moved from the top position to the bottom position. I know this is possible, because it is demonstrated in this video at the 00:24 mark https://www.youtube.com/watch?v=vXTujIVNRQU
I have connected a Y-splitter to the X2 port, however I found that the signal which is sent by the switch is not a standard servo signal. Does anybody know how to convert it into a servo signal to make it work ?
BTW, I am aware that the F2 port will activate a servo controlled by the bottom lever, but I am already using it to control the pitch.
I have connected a Y-splitter to the X2 port, however I found that the signal which is sent by the switch is not a standard servo signal. Does anybody know how to convert it into a servo signal to make it work ?
BTW, I am aware that the F2 port will activate a servo controlled by the bottom lever, but I am already using it to control the pitch.