Hi guys, I am a new member and I am looking for some help.
I have the Phantom v.1.1.1 with the following upgrades:
ZenMuse Gimbal
DJI upgrade board
Go Pro camera.
I just recieved my immersion 600mw vTx and I was wondering if I could direct solder it to the battery lead wires which connect directly to the upgrade board? I assume this would be ok?
Also, since I run the ZenMuse Gimbal and there is not a lot of space to mount the vTx underneath, where do you suggest a good mounting place would be?
Thank you!!!
I have the Phantom v.1.1.1 with the following upgrades:
ZenMuse Gimbal
DJI upgrade board
Go Pro camera.
I just recieved my immersion 600mw vTx and I was wondering if I could direct solder it to the battery lead wires which connect directly to the upgrade board? I assume this would be ok?
Also, since I run the ZenMuse Gimbal and there is not a lot of space to mount the vTx underneath, where do you suggest a good mounting place would be?
Thank you!!!