Hi everyone
Took my P3 professional out for a spin today and stupidly managed to hit a low hanging branch which caused it to crash.
There does not appear to be much physical damage beyond some scuff marks. All the blades were still attached and not damaged either.
Once I got it home I tried to power it up again and I can get it to start, the motors spin and the gimbal resets and holds but there is no camera signal.
I can move the gimbal from the controller but again no signal, there does not seem to be any cables loose that I can see and all looks ok with the gimbal.
There is however a double bleep buzzing noise from the gimbal followed by a continual buzz and the LED on the front of the gimbal is a solid red.
Really hope I can get this sorted and learn my lesson without it costing me a fortune to fix and repair.
Regards
Jim
Took my P3 professional out for a spin today and stupidly managed to hit a low hanging branch which caused it to crash.
There does not appear to be much physical damage beyond some scuff marks. All the blades were still attached and not damaged either.
Once I got it home I tried to power it up again and I can get it to start, the motors spin and the gimbal resets and holds but there is no camera signal.
I can move the gimbal from the controller but again no signal, there does not seem to be any cables loose that I can see and all looks ok with the gimbal.
There is however a double bleep buzzing noise from the gimbal followed by a continual buzz and the LED on the front of the gimbal is a solid red.
Really hope I can get this sorted and learn my lesson without it costing me a fortune to fix and repair.
Regards
Jim