Phanton 2 vision + won't post

[Radon]

Hi, I have not used my phantom in a while and the batteries were bad. I purchased 3rd part batteries. When I try to start up. I get a quick white flash on the LEDs then it starts beeping while it goes through a flash cycle.
I also tried a firmware reset...no change

20200501_142129[1].mp4

drive.google.com

 

[quaddamage]

Connect it to PC and see the error in logs there.
First check if Assistant shows something, if not - just open PuTTY and look at the messages logged at startup.
I wonder if you're fast enough to be able to capture the startup logs..

From the footage you sent I can't really tell if it's Ph2 on Ph3.. I assume you checked markings on the drone.

 

[crash1sttime]

Hi, I have not used my phantom in a while and the batteries were bad. I purchased 3rd part batteries. When I try to start up. I get a quick white flash on the LEDs then it starts beeping while it goes through a flash cycle.
I also tried a firmware reset...no change

20200501_142129[1].mp4

drive.google.com

Its the Phantom 2 vision plus, as you have the range extender on the remote

that said the Beeping is the naza saying there is an issue, this could be a number of things, but the first thing I would do is connect it to the assistant software

I have a guide below to using the software

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

and if the software wont install watch this one

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies