Phantom 3 S propeller guards.

[Earls Court]

I bought these 4X prop guards asking for and received confirmation- specifically for P3S guards. This is what I received and can’t find a way to fit them. Does anybody know anything about these, before I toss them and look again.

 

[SkyKing51]

Did they come with screws?

 

[Earls Court]

No, they came in ziplock packet and nothing else. I think I was sold a pup. Now to find the right ones for my P3S!

 

[Drone Freedom27]

Those are not P3S prop guards I ha e prop guards and they dont look like that.

 

[JerryA]

I have the same guards, They have 4 screws on each guard. They are meant to prevent tree leaves/branches from breaking the props.

 

[Drone Freedom27]

JerryA has the correct phantom 3 prop guards they have a notch and a clip that slide and clips into place. I never use my prop guards has I have juniper trees in my area and they average 30 to 40 feet tall. I on average fly 90 to 110 feet high never had a crash or run in

 

[Millersnutz]

I bought these 4X prop guards asking for and received confirmation- specifically for P3S guards. This is what I received and can’t find a way to fit them. Does anybody know anything about these, before I toss them and look again.

I think i I have a set at home that I have never used. You can have them but you will have to pay the shipping from Arizona.

 

[Millersnutz]

I think i I have a set at home that I have never used. I don't need them, so I'll send them to you. You will have to pay the shipping from Arizona.

 

[Squirrel!]

JerryA has the correct phantom 3 prop guards they have a notch and a clip that slide and clips into place. I never use my prop guards has I have juniper trees in my area and they average 30 to 40 feet tall. I on average fly 90 to 110 feet high never had a crash or run in

No. Jerry has aftermarket guards. The OP guards are also incorrect. The factory guards for the P3S only has 2 mounting holes. Uses the existing screws already holding the motors to the arms. They do come with slightly longer screws. CAUTION when removing guards to use the ORIGINAL SCREWS or the longer ones will protrude into the motor cavity, destroying the motor. They are, for all intents and purposes, a real PITA to use. This is the correct P3S guard.

 

[Drone Freedom27]

As the good sir stated above removing the current screws and installing new ones. I've had a couple people I know do this a d they knicked one of the wires for the ESC and now the Phantom 3 wont start because ESC error so it's a real shame. I'd just fly safe and not use propeller guards it's just a hassle for me. Plus slot of videos I watch the prop guards are the reason the drone gets stuck high in a tree.... drones without prop guards tend to tumble more and props dont get hung up on branches ect. landing legs totally different story hah.