I was wondering if anyone has hooked up to the Temperature sensor terminals on the main board. I was going to place a temp probe inside the phantom's body, but thought I would ask if anyone knew the hookup or specs for doing this at the board level.
I'm copying a photo from another thread, thanks to pixmanlajunta for the photo already numbered...also to OI photography and CityZen for the decipher on what's what on the image.
Item 20 is the Temperature pads....
1, 4, 7, 10: ESC ports (for the speed controllers in each arm)
2: + lead to battery connector
3: - lead to battery connector
5: Fan (not used), Vision 2+, with just the middle wire attaching to the Wifi module (to the white plug near the antenna connectors)
6: Motor control
8: Receiver connection A, plugs in to X1 on the NAZA
9: Receiver connection B, plugs in to X2 on the NAZA
11: Has 2 cables. The one with a 4-pin plug is the data connection to the NAZA, plugs in to EXP port. The one with a 3-pin plug is the power for the NAZA, plugs in to X3
12: Compass port (cable from the leg). The big black port hidden by that cable in your pic (and not numbered) is for the GPS cable in the lid of the Phantom
13: For the CANBUS port on the other leg
14: is labelled "Exp" (expansion?) on the motherboard. It's not plugged in to anything
15: Data connection to battery (to monitor and validate it)
16: Zenmuse gimbal connection
17: Video and power output for OSD/FPV Transmitter
18: NAZA v2
19: Receiver board
20: Connection for temp sensor (Not used, in regular P2 anyway)
I'm copying a photo from another thread, thanks to pixmanlajunta for the photo already numbered...also to OI photography and CityZen for the decipher on what's what on the image.
Item 20 is the Temperature pads....
1, 4, 7, 10: ESC ports (for the speed controllers in each arm)
2: + lead to battery connector
3: - lead to battery connector
5: Fan (not used), Vision 2+, with just the middle wire attaching to the Wifi module (to the white plug near the antenna connectors)
6: Motor control
8: Receiver connection A, plugs in to X1 on the NAZA
9: Receiver connection B, plugs in to X2 on the NAZA
11: Has 2 cables. The one with a 4-pin plug is the data connection to the NAZA, plugs in to EXP port. The one with a 3-pin plug is the power for the NAZA, plugs in to X3
12: Compass port (cable from the leg). The big black port hidden by that cable in your pic (and not numbered) is for the GPS cable in the lid of the Phantom
13: For the CANBUS port on the other leg
14: is labelled "Exp" (expansion?) on the motherboard. It's not plugged in to anything
15: Data connection to battery (to monitor and validate it)
16: Zenmuse gimbal connection
17: Video and power output for OSD/FPV Transmitter
18: NAZA v2
19: Receiver board
20: Connection for temp sensor (Not used, in regular P2 anyway)