Phantom 1...The model prior to the self tightening Props
Added a BGC Gimbal. I added Pitch Control to this setup.
On the Phantom Side:
Plugged into the 7th channel of the NAZA, into into the Pitch connector on the BGC Gimbal.
On the Controller Side:
Removed the trim pot off the board, and wired in a 10K Potentiometer.
Within the NAZA-M V2 Assistant Software:
In the Advanced Button/Gimbal tab enabled the Gimbal Switch radial
In the Basic Button/RC tab performed the X1 Calibration
The Gimbal twitches on pitch.
When I go into the NAZA-M V2 Assistant Software Basic/RC tab and view the X1 channel under "Sticks Monitor". The indicator itself is twitching on the scale which is matching up to the behavior of the Gimbal Pitch.
My question is how to understand where this information is coming from.
You start with the Controller. The Potentiometer to the Controller. Sends through RC into the Receiver on the Phantom. Goes into the NAZA. Than on to the Gimbal Controller.
Is this a fair flow?
Added a BGC Gimbal. I added Pitch Control to this setup.
On the Phantom Side:
Plugged into the 7th channel of the NAZA, into into the Pitch connector on the BGC Gimbal.
On the Controller Side:
Removed the trim pot off the board, and wired in a 10K Potentiometer.
Within the NAZA-M V2 Assistant Software:
In the Advanced Button/Gimbal tab enabled the Gimbal Switch radial
In the Basic Button/RC tab performed the X1 Calibration
The Gimbal twitches on pitch.
When I go into the NAZA-M V2 Assistant Software Basic/RC tab and view the X1 channel under "Sticks Monitor". The indicator itself is twitching on the scale which is matching up to the behavior of the Gimbal Pitch.
My question is how to understand where this information is coming from.
You start with the Controller. The Potentiometer to the Controller. Sends through RC into the Receiver on the Phantom. Goes into the NAZA. Than on to the Gimbal Controller.
Is this a fair flow?
Last edited: