PC doesn't recognize when Phantom is plugged in

Mako79 said:
Judging from the link below, If it uses the same pin connectors as the GPS plug, then unplug it and clean the connectors.
You did mention of a shell swap. Also check if you installed in backwards (is it possible?).

http://www.justhobbies.net.au/djip2-s04 ... -usb-cable

probably gonna drop by the store and let them check. Hoping that it isn't the USB interface pin connector that went bad.

Because after I crashed the drone into the tree the other time, I went back home to plug it in and the phantom vision assistant could still recognize it.

It is just after i changed the shell and this happened. weird.
 
I had the same issue.

The wires going to the USB connector at the bottom of the remote are extremely fragile.
One of them had broken.
A quick solder job fixed it.

I had done several mods to the remote; I suspect opening / closing it so many times caused it.
 
CapnBob said:
I had the same issue.

The wires going to the USB connector at the bottom of the remote are extremely fragile.
One of them had broken.
A quick solder job fixed it.

I had done several mods to the remote; I suspect opening / closing it so many times caused it.

Thanks for your input. Gonna check that particular area
 

Members online

Forum statistics

Threads
143,567
Messages
1,471,527
Members
105,568
Latest member
Starbase