OK so I go to upgrade to 1.7.0060, put it on the SD card, P3P going through the normal upgrade process and taking a long time as usual. I go out to find some Easter Eggs outside, come in, and the upgrade is done, flashing green light, all good. I upgrade the controller from the app, all good. I go outside and I cannot get an image. I can connect and start the motors but no video signal. I notice the gimbal is limp. I reboot the bird and see if that helps, nothing, same issue. I noticed when I tried to power down the drone I get a flashing red light on the battery and a delay when I shut down. I have not seen this before. I have tried using other batteries, same issue. I have tried to do the firmware upgrade again but I get “The firmware on the SD card is identical….” Tried rebooting several times, tried upgrading firmware several times. I have uploaded the videos here of the bootup and the shut down process.
I am stumped as to what is the issue. Can anyone help? I have tried to downgrade the firmware version by forcing a firmware upgrade but that is not working as well. Take a look at the videos and let me know if anyone has seen this before.
Startup:
Shutdown
Thank you,
I am stumped as to what is the issue. Can anyone help? I have tried to downgrade the firmware version by forcing a firmware upgrade but that is not working as well. Take a look at the videos and let me know if anyone has seen this before.
Startup:
Shutdown
Thank you,