I have a Phantom 2 which has flown perfectly and never crashed, i.e., no physical damage. Today it would not start up properly (not all green lights) then all lights went out. I restarted it with the same results. I swapped batteries, with the same results. Then I plugged the P2 in to my pc via usb but the NAZA-M-V2 app would not recognize it (no remote control response), even though I heard the USB connect beep, but the gimbal will respond to the angle control on the remote. I restarted the pc and got the same negative results. I have calibrated the P2 before and the firmware is current as of a month ago.
Also, while it was plugged in to the usb, after a few minutes the props suddenly started spinning as if I had given it the start up command. I shut down the battery to stop it.
Jay
Santa Cruz, CA
Also, while it was plugged in to the usb, after a few minutes the props suddenly started spinning as if I had given it the start up command. I shut down the battery to stop it.
Jay
Santa Cruz, CA