Hi guys - new to the forum, and hope you can help.
I have just purchased the Phantom FC40 and had a gentle play around with it - how ever I have the following issue which I hope you can help with.
1) I live in the UK and I am unsure if the transmitter should be set to CE compliance (one beep once turned on) or FCC Compliance (Two beeps when its turned on - which mine currently does)
2) I flew it shortly the other day - all was fine but a gust of wind took it sideways into a garden bench which broke one of the prop guards and nothing else so it seems. It had gone through the start up sequence fine, and after that I went through the GPS location process and the LED flashed in the correct sequence for that as well
3) Downloaded the NAZA-M assistant to help set the transmitter and fine tune the 'copter but noticed that at start up ( ie transmitter on - battery pack in - connect up) the LED is flashing Three Red in quick succession and One Green and nothing else. The manual mentions not to connect to the PC until the 'start up' sequence has completed - but this has been sitting there with the three red - one green scenario for about five minutes and nothing else is happening.
I do not want to connect to the PC - and really not sure what to do as the manual does not seem to mention this sequence. I have even shut both down and fitted a fully charged battery to see if it was that - but no change.
I appreciate this will be under warranty should it be an equipment failure but unsure if the 'bump' has caused issues............. HELP PLEASE
Thanks
All the best
Viking(Quadcopter virgin !!!! :lol: :lol: )
I have just purchased the Phantom FC40 and had a gentle play around with it - how ever I have the following issue which I hope you can help with.
1) I live in the UK and I am unsure if the transmitter should be set to CE compliance (one beep once turned on) or FCC Compliance (Two beeps when its turned on - which mine currently does)
2) I flew it shortly the other day - all was fine but a gust of wind took it sideways into a garden bench which broke one of the prop guards and nothing else so it seems. It had gone through the start up sequence fine, and after that I went through the GPS location process and the LED flashed in the correct sequence for that as well
3) Downloaded the NAZA-M assistant to help set the transmitter and fine tune the 'copter but noticed that at start up ( ie transmitter on - battery pack in - connect up) the LED is flashing Three Red in quick succession and One Green and nothing else. The manual mentions not to connect to the PC until the 'start up' sequence has completed - but this has been sitting there with the three red - one green scenario for about five minutes and nothing else is happening.
I do not want to connect to the PC - and really not sure what to do as the manual does not seem to mention this sequence. I have even shut both down and fitted a fully charged battery to see if it was that - but no change.
I appreciate this will be under warranty should it be an equipment failure but unsure if the 'bump' has caused issues............. HELP PLEASE
Thanks
All the best
Viking(Quadcopter virgin !!!! :lol: :lol: )