Hi.
I have just updated my Phantom v1 with a new PC330CB board as well as adding the H3-2D.
After the upgrade I have upgraded the software to the last version and everything seems to work well - except for using the new lever on the remote control - for moving the H3-2D.
Using the PC program I can see all the movements I do on the other controls on the RC. However not the X1 axis. Even if I open the RC and turn the pot with a screwdriver no movement gets detetcted.
The receiver in the Phantom is the two aerial D-bus type. It has two plugs that I have connected to the X2 and X1 plugs inside the Phantom. Removing the one connected to X1 makes no difference but switching them makes nothing work.
Really dont understand so any help will be greatly appreciated!
Thank you!
I have just updated my Phantom v1 with a new PC330CB board as well as adding the H3-2D.
After the upgrade I have upgraded the software to the last version and everything seems to work well - except for using the new lever on the remote control - for moving the H3-2D.
Using the PC program I can see all the movements I do on the other controls on the RC. However not the X1 axis. Even if I open the RC and turn the pot with a screwdriver no movement gets detetcted.
The receiver in the Phantom is the two aerial D-bus type. It has two plugs that I have connected to the X2 and X1 plugs inside the Phantom. Removing the one connected to X1 makes no difference but switching them makes nothing work.
Really dont understand so any help will be greatly appreciated!
Thank you!