I finally got my Futaba 8FGS, and I'm about to install the receiver on my Phantom. The "problem" is that my stock receiver is the upgraded version with 2 antennas, and it's connected to the Naza controller by 2 identical 3 wire cables(connected to X1 and X2)
So my question is, do I have to use both cables when I'm replacing the receiver?
or
Just connect one cable to the S-bus(R6208) and the other end to the X1 port on Naza?
So my question is, do I have to use both cables when I'm replacing the receiver?
or
Just connect one cable to the S-bus(R6208) and the other end to the X1 port on Naza?