Hoping someone can help me with this. I've tried almost everything and cannot figure this out.
Have a new Dj6 remote and went through the process of binding with the Phantom 2. It appeared it was successful as the red LED on the underside turns off when I power on the remote. I get three beeps and it turns green (remote). I initially was getting a solid red light, but went through the process of updating the firmware and finally got it to turn green when it powered on. However, outside of that little LED light turning off, it appears to not have any connection with the Phantom. The sticks won't start the motors and the gps switching up and down does nothing. Any ideas of what could be the issue? Any help would be greatly appreciated!
Have a new Dj6 remote and went through the process of binding with the Phantom 2. It appeared it was successful as the red LED on the underside turns off when I power on the remote. I get three beeps and it turns green (remote). I initially was getting a solid red light, but went through the process of updating the firmware and finally got it to turn green when it powered on. However, outside of that little LED light turning off, it appears to not have any connection with the Phantom. The sticks won't start the motors and the gps switching up and down does nothing. Any ideas of what could be the issue? Any help would be greatly appreciated!