Credit goes to RickM
I haven't seen this before and I think it should be a sticky. Apologies if ii is a repost.
I think it would be good last resort if your gimbal/firmware/naza fails to update correctly.
Even better if you want to roll back your firmware.
http://www.droneslinger.com/software.html
I haven't seen this before and I think it should be a sticky. Apologies if ii is a repost.
I think it would be good last resort if your gimbal/firmware/naza fails to update correctly.
Even better if you want to roll back your firmware.
http://www.droneslinger.com/software.html
My phantom 2 Vision + did the same thing after a software update. The gymbol stopped working, the camera working great, flying was great, everything but the gymbal worked. I found I had to reset the phantom. There is no reset button you have to actually short across 2 pins on the processor to make this happen and then reload the software. I found this. If you follow it exactly as he shows it, your gymbal should work. I did and now everything is working great again. I didn't use the wire jumpers like he did, I got a small jumper from a computer store and that worked good. Good luck