Hello. I'm hoping someone can help me. I have a Phantom V1.1.1 with a chineese gimbal, using a Gopro Hero 3+. I do not have any pitch (tilt) on the gimbal. I have enabled the gimbal switch in the Naza software, installed the signal wire to the bottom of the F2 port on the Naza board, and the other end of the signal wire to the top pin (pitch) on the gimbal. The gimbal stays steady and level, but I do not have any tilt. I bought another gimbal thinking this was the problem, but when it arrived and I installed it, this gimbal is the same - no tilt. I am getting very frustrated.
Your help is very much appreciated, please email me on
[email protected]
cheers
John
Your help is very much appreciated, please email me on
[email protected]
cheers
John