Hi,
I would appreciate immensely if anyone can help. I had a crash today with the gimbal attached (H3 3D). It was not too badly damaged and I have it physically repaired. When I turned the Phantom on however the gimbal went crazy and just wouldn't stabilise. I managed to undertake successfully the reset and at least now the gimbal is going crazy and tearing itself to pieces - the little LED light has changed from red to green. However when I go to the Phantom Software Assistant to reload the firmware there is nothing. There is firmware for the battery and main controller etc but nothing for the H3 3D gimbal. I am however still waiting on the video output cable from the gimbal to the camera so this is not yet attached. Am I right in thinking that whenever I have this cable attached then the software will recognise the gimbal again? If not, then does anyone have any ideas about how to get the firmware on the Assistant Software and ultimately onto the gimbal??
Thanks,
Liam (Ireland)
I would appreciate immensely if anyone can help. I had a crash today with the gimbal attached (H3 3D). It was not too badly damaged and I have it physically repaired. When I turned the Phantom on however the gimbal went crazy and just wouldn't stabilise. I managed to undertake successfully the reset and at least now the gimbal is going crazy and tearing itself to pieces - the little LED light has changed from red to green. However when I go to the Phantom Software Assistant to reload the firmware there is nothing. There is firmware for the battery and main controller etc but nothing for the H3 3D gimbal. I am however still waiting on the video output cable from the gimbal to the camera so this is not yet attached. Am I right in thinking that whenever I have this cable attached then the software will recognise the gimbal again? If not, then does anyone have any ideas about how to get the firmware on the Assistant Software and ultimately onto the gimbal??
Thanks,
Liam (Ireland)
