Hi all,
My P3P is only a few weeks old and has just 8 flights on it.
I did the latest firmware upgrade the other day and all went well, also did the IMU and gimbal calibrations straight after that.
On the second flight after this I noticed the horizon was not level, not far off but not perfect so I tried the gimbal calibration again but get the following odd result where it calibrates to the left and right but then just drops loose like so:
It does eventually very slowly creep back into the correct position but this can't be right surely? Never used to do this when I calibrated previously?
It's never had a hard landing or crash.
Any advice?
Thanks!
My P3P is only a few weeks old and has just 8 flights on it.
I did the latest firmware upgrade the other day and all went well, also did the IMU and gimbal calibrations straight after that.
On the second flight after this I noticed the horizon was not level, not far off but not perfect so I tried the gimbal calibration again but get the following odd result where it calibrates to the left and right but then just drops loose like so:
It does eventually very slowly creep back into the correct position but this can't be right surely? Never used to do this when I calibrated previously?
It's never had a hard landing or crash.
Any advice?
Thanks!