We recently tried reverting back to the stock DJI radio from the Futaba 8FJ since we want to use the Futaba on another copter. Now sure why, but the stock radio wasn't working and not even recognized by NAZA (switched everything back to factory, and traditional instead of d bus).
So then we went back to the Futaba, which was recognized by NAZA. Recalibrated and changed back to d bus.
Upon the first test flight again, everything worked fine, the props spun for take off.
HOWEVER, now the throttle isnt working. We can't get it off the ground.
No settings were changed on the Futaba itself. Is there anything in NAZA we need to change?
We re-calibrated the Futaba as well as the copter and all motions are recognized.
Seems odd that only throttle up/down isn't working. Hoping its an easy fix.
Any comments or advise appreciated!
Thanks
So then we went back to the Futaba, which was recognized by NAZA. Recalibrated and changed back to d bus.
Upon the first test flight again, everything worked fine, the props spun for take off.
HOWEVER, now the throttle isnt working. We can't get it off the ground.
No settings were changed on the Futaba itself. Is there anything in NAZA we need to change?
We re-calibrated the Futaba as well as the copter and all motions are recognized.
Seems odd that only throttle up/down isn't working. Hoping its an easy fix.
Any comments or advise appreciated!
Thanks