I just installed the H3-3D anti interference board and had a hell of a time getting the phillips screws out at the tips of the propellors. They are super tight and seem to be easy to strip. After I finished putting all the hex screws back in everything seems tight and solid enough to fly without those little phillips screws. Like really solid.
I'm planning to install a video transmitter soon and I'm just afraid if I keep taking those screws in and out I'm eventually going to strip them while they're in my Phantom, which would be very bad.
What do you guys think? OK to fly without those screws? I could always screw them in without tightening them all the way but I don't see how that would be any better than just leaving them out. And if they're not in tight they could fall out from vibration.
Anybody know where I can get aftermarket screws that will resist stripping a little bit better?
I'm planning to install a video transmitter soon and I'm just afraid if I keep taking those screws in and out I'm eventually going to strip them while they're in my Phantom, which would be very bad.
What do you guys think? OK to fly without those screws? I could always screw them in without tightening them all the way but I don't see how that would be any better than just leaving them out. And if they're not in tight they could fall out from vibration.
Anybody know where I can get aftermarket screws that will resist stripping a little bit better?