I just upgraded my P2 with H3-2D from V1.08 to V2.0
Mainly did so to use the ground station which I had bought way back in Jan 2014.
The GS worked just fine, but after reviewing the videos from 2 flights, I noticed that the craft seems to wobble a lot more on the yaw axis than I used to remembered. I took about a dozen videos on the V1.08 and recall that everything was buttery smooth with no hint of wobble unless I was really messing with it. Now, it seems to wiggle left right all the time, even on ATTI mode.
Did I do something wrong? Do I need to adjust the gains?
or...
Is there something wrong with V2.0 firmware and I should immediately downgrade back to V1.08 while I still can?
Why don't I just go V3.0? Well, I am not sure if that will fix the issue an I don't trust the complexity of the new restricted zone stuff. More bugs to make you lose the P2.
Anyone else seen this issue?
Mainly did so to use the ground station which I had bought way back in Jan 2014.
The GS worked just fine, but after reviewing the videos from 2 flights, I noticed that the craft seems to wobble a lot more on the yaw axis than I used to remembered. I took about a dozen videos on the V1.08 and recall that everything was buttery smooth with no hint of wobble unless I was really messing with it. Now, it seems to wiggle left right all the time, even on ATTI mode.
Did I do something wrong? Do I need to adjust the gains?
or...
Is there something wrong with V2.0 firmware and I should immediately downgrade back to V1.08 while I still can?
Why don't I just go V3.0? Well, I am not sure if that will fix the issue an I don't trust the complexity of the new restricted zone stuff. More bugs to make you lose the P2.
Anyone else seen this issue?
