Hello,
When I pan my camera on my Phantom 3 Standard downward, the camera disconnects and goes into the gyro mode of spinning all over the place (like when you start up the drone). It will not reconnect during flight until I land the drone and shut off / start back up. If I take back off and pan the camera down again, it will disconnect again (same as before).
Any thoughts on what could be causing that? I had replaced the ribbon cable a while back for a problem with the camera, and also replaced the chip board for one of the motors as it was causing bumping in the functions.
Anyone else see this happen before?
When I pan my camera on my Phantom 3 Standard downward, the camera disconnects and goes into the gyro mode of spinning all over the place (like when you start up the drone). It will not reconnect during flight until I land the drone and shut off / start back up. If I take back off and pan the camera down again, it will disconnect again (same as before).
Any thoughts on what could be causing that? I had replaced the ribbon cable a while back for a problem with the camera, and also replaced the chip board for one of the motors as it was causing bumping in the functions.
Anyone else see this happen before?
