I seem to struggle a bit with it.. Not sure if it's just me. When I put it in I have a hard time because I can't see where that inside knob is to push it steadily in place. When I pull it out I don't know where to grab the gimbal to least disturb it..?
Do you have a method of putting this gimbal on/off?
- Thread starter 30secs
- Start date
msinger
Approved Vendor
- Joined
- Oct 30, 2014
- Messages
- 32,177
- Reaction score
- 10,928
- Location
- Harrisburg, PA (US)
- Website
- phantomhelp.com
Do yourself a favor and grab one of these... http://www.ebay.com/itm/251976929619
Done with all the struggling and proper techniques... and kill two birds with one stone... lens cover and gimbal support.
Done with all the struggling and proper techniques... and kill two birds with one stone... lens cover and gimbal support.
Line up the tab and groove
To remove, place one finger on the top gimbal plate and use the other to slid it off.
msinger
Approved Vendor
- Joined
- Oct 30, 2014
- Messages
- 32,177
- Reaction score
- 10,928
- Location
- Harrisburg, PA (US)
- Website
- phantomhelp.com
Once you figure out how to do it, the OEM gimbal lock is very effective. The design is much better than the P2V+'s lock.
I agree, and to pay $25 for a 3d printed one is insane. Maybe because I have a printer that prints a hell of a lot better than that one but hell, I will make them for $15.. Even then its still a rip. Not to mention once you add a nd filter it won't fit anymore.
Last edited:
Good idea... too late for me... I got the black rubber... only available in that one color when I purchased.
Similar threads
