Just finished rebuilding my P2 after a stupid crash, seeing as I had to replace the shell I decided to run the cables for iOSD, flytrex and gimbal a different way from the norm to try and get a tidier finish.
iOSD is mounted on the back of the gimbal with tape and then the fpv hub is mounted to the iOSD...
The flytrex is then placed right above it out of the way...
Finally I cut one of the cooling fins out of the cooling vent on the canbus side and ran the iOSD can bus, zenmuse and flytrex cables through it, taking out one fin with a sharp knife is just big enough to fit the canbus connector through and looks a lot tidier than connecting on the leg...
The canbus port has been moved inside the shell to tidy things up further. Now I have a good amount of space left to mount the avl58.
iOSD is mounted on the back of the gimbal with tape and then the fpv hub is mounted to the iOSD...
The flytrex is then placed right above it out of the way...
Finally I cut one of the cooling fins out of the cooling vent on the canbus side and ran the iOSD can bus, zenmuse and flytrex cables through it, taking out one fin with a sharp knife is just big enough to fit the canbus connector through and looks a lot tidier than connecting on the leg...
The canbus port has been moved inside the shell to tidy things up further. Now I have a good amount of space left to mount the avl58.
