Hi all, I have a P3A & iv'e had it since June 2016. I noticed some cracks around the area where the motors mount & I have been told this does happen. The shell is "version 2". I got a brand new replacement shell yesterday from local DJI dealer here on the Gold Coast. It too is "version 2". I stripped down the old one & swapped all components over to the new shell. I took particular care not to tighten the motor screws too tight but did the gentle wrist tightness. Took it to my local haunt & all went well & I brought it back after ten minutes & discovered cracks starting in two of the motor mounts. I am at my wits end as to why this would happen. Your going to ask the question why I did not sent it in to be done. In Oz it would be a big waiting list at this time of year & the cost would be heavenly. Looking forward to your input guys.
Thanks Dave...
Thanks Dave...