Despratly need to find out what is going on with my p2v that just will not fly. I thought I finely got my phantom vision that I have been trying to restore all ready to fly today and it just will not fly. at all . every time I try to take off it just flips up side down and crashes. tried about 20 times and it just will not take off with out flipping over. I even went and redid the imu calibration and have all the default gains set right and still keeps doing it. I even tried hand launching it 2 times and it just does a barrel roll and tumbles to the ground and makes like a lawn mower. Im about to just throw the frigging thing on the ground and stomp it to a million bits.
during my over haul the motors were not acting right so I replaced the escs and the motors still were acting weird and some times stuttering even after replacing the esc's so I even went and replaced all 4 motors They were t motors to no less.. and even replaced the wires to. and i also had to replace the gps . It seemed like every thing was all good to go when I bench tested it. The motors were seeming fine. So today after getting a new DJI battery I figured it was time to try and see how she flys and then kept getting the flipping tumbling bull crap and I am at my wits end as to what the heck it can be. only thing I did not replace on this was the naza and the main board and the compass. So for heavens sake does any one have a clue what the hell could be causing this thing not to fly with out wanting to turn its self up side down and crash?
during my over haul the motors were not acting right so I replaced the escs and the motors still were acting weird and some times stuttering even after replacing the esc's so I even went and replaced all 4 motors They were t motors to no less.. and even replaced the wires to. and i also had to replace the gps . It seemed like every thing was all good to go when I bench tested it. The motors were seeming fine. So today after getting a new DJI battery I figured it was time to try and see how she flys and then kept getting the flipping tumbling bull crap and I am at my wits end as to what the heck it can be. only thing I did not replace on this was the naza and the main board and the compass. So for heavens sake does any one have a clue what the hell could be causing this thing not to fly with out wanting to turn its self up side down and crash?