Can not activate "F" mode

[Chuck Boo]

After take off, flipping the s1 switch nothing changes. I can not get to the intelligent flight modes screen. It worked before. I did the recent software upgrade. Any ideas?

 

[msinger]

Make sure you have the "Main Controller Settings" --> "Multiple Flight Modes" setting enabled in DJI GO.

 

[Chuck Boo]

Thank you! It was not enabled like you said.

 

[msinger]

After installing new firmware on your Phantom, go into DJI GO and double-check everything. Many of them are reset back to their default settings.

 

[Chuck Boo]

Your right they were all set back to defaults. For some reason I cannot get a good satellite picture. I downloaded goggle earth. Any Ideas? I get solid green screen or a picture way up in the clouds.

 

[msinger]

For some reason I cannot get a good satellite picture.

A good satellite picture where? I'm not sure what you're trying to do.

 

[Jthomp]

Your right they were all set back to defaults. For some reason I cannot get a good satellite picture. I downloaded goggle earth. Any Ideas? I get solid green screen or a picture way up in the clouds.

I don't think you will get a "good satellite picture" if you are expecting a live picture to be sent down to your viewing device. What you would ordinarily get is a static photo from space of the area you are physically located at - one which was taken who-knows-how-long-ago. The fact that you get a solid green screen or "a picture way up in the clouds" tends to make me think there is something awry with your software setup in your viewing device. Maybe it would help to do a re-install?

 

[Chuck Boo]

I don't get the "static photo from space". Thanks for your reply.

 

[Philltayl]

I don't get the "static photo from space". Thanks for your reply.

Try and read the operating manual please.......