Can I repair this myself?

[Phantom fool]

Was flying and everything was OK until the ground rose up and grabbed my P3P out of the air. It seemed OK until I put it in the backpack and subsequently removed it. Upon removal, II think I squeezed too hard and one part of the shell seems to have separated (top from bottom) and is a little offset. This was not the result of the crash, rather my incredible hulk-like strength pulling the aircraft from the case.

Pic is below. Question is, can I repair this myself or is this something I have to send it back for? I'm not sure how to take the shell apart to re-align everything. Is there a video on how to do that somewhere?

 

[ShelbyPoker]

No pic ?

 

[msinger]

Here's a video showing how to take the shell apart:

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[Phantom fool]

Pics now. Took a minute to upload

It's a pirates life for me

 

[Phantom fool]

Thanks msinger. So do you think I cab just open it and re-align the shell, or does it need to be replaced?

 

[Ian Welsh]

I had this happen to mine on one side. If you manage to look at a picture of the casing you will see that one half clips into the other. If you know how it goes for me it was just a matter of squeezing the correct half to manipulate it back into the clip. To split the case may leave you having to do the same procedure but all around.

 

[msinger]

I think you can pop it back in place. It'll probably require opening the shell though.

 

[dirkclod]

I would just loosen the screws to start with and try and move it back together first and retighten . That has worked for me before.
Sometimes it hasn't and had to do as msinger said .

 

[msinger]

I would just loosen the screws to start with and try and move it back together

The shell snaps together, so loosening the screws probably won't help in this case. The OP might be able to push it back together. I wouldn't suggest forcing it too much though.

 

[Multicoptertec]

Squeeze the TOP half of the shell inward directly above those snap features, and apply a slight downward pressure. Do one at a time.

 

[dirkclod]

The shell snaps together, so loosening the screws probably won't help in this case. The OP might be able to push it back together. I wouldn't suggest forcing it too much though.

Aware as I have took mine apart
Loosen the screws will give it enough play to slip that lip back in place if that all it is .

 

[LuvMyTJ]

Aware as I have took mine apart
Loosen the screws will give it enough play to slip that lip back in place if that all it is .

Took it apart? Pretty sure you are intimately aware of most everything under that shell.

 

[dirkclod]

Took it apart? Pretty sure you are intimately aware of most everything under that shell.

You would think so if ya read any in here huh
lol