Camera blurry after replacement

szymczaksteve · Jul 9, 2017

Hello,
I recently sent my p4p back to DJI for repair after a crash. Since I have DJI refresh they sent me a “like new” one instead of repairing my old one. However the new drone camera seems to be have half as much detail and image quality as my original drone and to me is looking slightly off center on the drone. I have did a factory reset and an firmware refresh with no luck.

Any suggestions??

alokbhargava · Jul 9, 2017

You can only set the SW settings using dji go 4 app but if it's a hardware issue, better contact dji.

szymczaksteve · Jul 11, 2017

I’m sending it back to DJI to see what they say.

dgriffnz · Jul 21, 2017

My original camera was out of focus in the centre of the image. Local dealer replaced the whole camera/gimbal assembly under warranty. The difference was very clear, instantly. DJI are sending out some poorly focused units.