Allan H. got his in and here is a nice description of how he setup the pitch function on his Phantom:
OK, I have to go to a graduation tonight, but will be working with jlcamp7 to get this cleanly documented.
Basically for the Phantom, I removed the plug from the front right leg and ran the yellow, green, and blue wires supplied through that hole. Inside, the yellow wire goes to the top pin on F2 (ground), the blue wire goes to the bottom pin on F2 (the middle pin is left open, that's +5v). The green wire connects to the bottom pin on F1. That's it inside, but I did pull the gray/red wire through the front left hole to use to power the gimbal.
Now, on the gimbal, you have 3 pins to the right side of the edge with the USB connector. Left is yellow, center is green, and right is blue. The blue is not used on the Phantom, but can be used on an 8 channel radio system.
In the NAZA software, you need to enable the gimbal, set the frequency to 400, and I changed both gains to 5.00.
In the BGC software, I changed the pitch min angle to 0, so when the 7th controller screw is all the way counterclockwise (as viewed from behind), the camera will be straight ahead. If not, the camera will point straight up, and I didn't want to chance that flying FPV. Also turned off the INC.MODE. so the 7th controller screw will set absolute position, not relative.
I do have some screen shots of the software, and will take the Phantom apart and take a few more shots there.
Also, I somehow wiped all the settings from my gimbal, and screwed up the calibration. I figured out how to reset everything last night, so I'll type that up and get that to you or out on this site soon. It's not hard, and no one should need to send anything back if the calibration is off or there are no settings in the software.
Thanks.