Hi guys,
My Phantom 2 Vision+ crashed, and after inspection I noticed that the cause of the crash was ... melted motor mounts, that are part of the body.
Camera does not respond, Gimbal is bended (stuck), drone body is melted on 2 motor mounts, legs are ollapsed, props need to be replaced.
Pretty intense damage.
Have 3 questions:
1. Did someone have this or similar issue?
I checked the forum and could not find "body melting". Am I just "lucky"?
2. Any recommendations on how to prevent this in the future? (if I decide to keep/repair DJI)
3. Does it make sense to report to DJI with suggestion to make a heat-resistant motor mounts that will prevent body melting?
Sorry for too many questions, my frustration motivates me to act.
Thanks,
Vasiliy
My Phantom 2 Vision+ crashed, and after inspection I noticed that the cause of the crash was ... melted motor mounts, that are part of the body.
Camera does not respond, Gimbal is bended (stuck), drone body is melted on 2 motor mounts, legs are ollapsed, props need to be replaced.
Pretty intense damage.
Have 3 questions:
1. Did someone have this or similar issue?
I checked the forum and could not find "body melting". Am I just "lucky"?
2. Any recommendations on how to prevent this in the future? (if I decide to keep/repair DJI)
3. Does it make sense to report to DJI with suggestion to make a heat-resistant motor mounts that will prevent body melting?
Sorry for too many questions, my frustration motivates me to act.
Thanks,
Vasiliy